De Dietrich DRS 915 JE Guide D'installation & D'utilisation page 28

Masquer les pouces Voir aussi pour DRS 915 JE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

28
Installation
Take utmost care when handling
your appliance so as not to cause
any damages to the cooling unit
with consequent possible fluid
leakages.
During normal operation, the condenser
and compressor at the back of the appli-
ance heat up considerably. Always ensure
that there is adequate ventilation as a fail-
ure to do this will result in component fail-
ure and possible food loss. See installa-
tion instructions.
Important: if the supply cord is damaged,
it must be replaced by a special cord or
assembly available from the manufacturer
or its service agent.
Positioning
Unpack the cabinet and check that it is in
good condition and free of any transport
damage.
The appliance must not be located close
to radiators or gas cookers.
Avoid prolonged exposure of the appli-
ance to direct sunlight.
For safety reasons, minimum ventilation
must be as shown in Fig.
Attention: keep ventilation openings clear
of obstruction.
It is necessary that the niche is provided
with a conduct of venti-lation having the
following dimensions:
Depth: 50 mm
Width: 540 mm
The climate classification can be found on the
rating plate, which is located inside the cabi-
net on the left hand wall.
The following table shows which ambient tem-
perature is correct for each climate classifica-
tion:
Climate
classification
SN
N
ST
T
for an ambient
temperature of
+10 to +32 °C
+16 to +32 °C
+16 to +38 °C
+16 to +43 °C

Publicité

Table des Matières
loading

Table des Matières