D-Link DP-301P+ Guide D'installation page 3

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
Troubleshooting
1. How do I configure my DP-301P+ print server without the CD?
To access the print server's web configuration, please enter the following into the
browser.
dlink-XXXXXX (where XXXXXX is the last 6 characters of the MAC address stated on
the label)
For example if the MAC address is 00179A5CAACF, you would enter dlink-5CAACF
into the browser.
2. How do I factory reset my DP-301P+ print server?
• This can be done through the web configuration in MAINTENANCE under
Save/Restore Settings. Click on Restore Device tab.
3. What printers are compatible with my D-Link print server?
• A printer compatibility list is provided within the manual. For the most up to date printer
compatibility list, please refer to www.dlink.eu.
4. What can I do if my print server is not working correctly?
• Check the LEDs on the print server. The power, ACT and LPT should be on.
• Check that all the cables are firmly connected at both ends
• Power the print server off for 20 seconds, and then power it back on.
5. How do I setup a printer under Mac OS X?
• Open the "Printer Setup Utility" which can be found in the /Applications/Utilitys
• Click Add printer and select " IP Printer"
• Select "Line Printer Daemon-LPD" form the "Protocol" list
• Enter the TCP/IP (or DNS name) of the printer into the "Address" box and enter queue
name into "Queue box".
• Select the make of the printer from the "print Using" list.
• Select printer model from "model list"
• Click Add The printer will be available from the "printer List ".
• Select "Quit" from the menu and the setup is now complete
Technical Support
Thank you for choosing D-Link products. For further information, support, product drivers and
manuals, please visit the D-Link website at www.dlink.eu.
www.dlink.co.uk
: 08456 12 0003
3

Publicité

Table des Matières
loading

Table des Matières