Maintenance Instructions; Moving And Storage Instructions - Schumacher Electric SJ1328 Guide D'utilisation

3. Open the protective cover of the DC
power outlet on the jump starter.
4. Plug the 12V DC device into the DC
power outlet and turn on the 12V DC
device (if required).
5. If the 12V DC device draws more than
15A or has a short circuit, the internal
circuit breaker of the jump starter will
trip and disconnect the power to the
device. Disconnect the 12V DC device.
The breaker will automatically reset
after an overload occurs.
6. When finished, turn off the DC device
(if required) and unplug from the DC
power outlet.
CAUTION: Do not use the jump starter to
run appliances that draw more than 15A DC.

7. MAINTENANCE INSTRUCTIONS

7.1 After use and before performing
maintenance, unplug and disconnect
the jump starter.
7.2 Use a dry cloth to wipe all battery corrosion
and other dirt or oil from the battery clips,
cords and the jump starter case.

8. MOVING AND STORAGE INSTRUCTIONS

8.1 Store inside, in a cool, dry place.
8.2 Do not store the clips on the handle,
clipped together, on or around metal, or
clipped to cables. The clips on the jump
starter are live when the switch is in the
ON position and will produce arcing or
sparking if they come in contact with each
other. To prevent accidental arcing, always
place the switch in the OFF position and
keep the clips on the storage holders when
not using it to jump start a vehicle.
8.3 If the jump starter is moved around the
shop or transported to another location,
take care to avoid/prevent damage to the
cords, clips and jump starter. Failure to
do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store the
jump starter in or on any area or surface
9. TROUBLESHOOTING
PROBLEM
The jump starter won't
jump start my car.
POSSIBLE CAUSE
Clamps are not making a good
connection to the battery.
Connections are reversed.
The jump starter's battery is not
charged.
The vehicle's battery is defective.
• 8 •
NOTE: Extended operation of a 12V DC
device may result in excessive battery drain.
Recharge the jump starter immediately after
unplugging the 12V DC device.
12V DC ESTIMATED RUN-TIMES
APPLIANCE TYPE
Cell phone
Fluorescent light
Radio, fan
Depth finder
Camcorder
Electrical tool
Electric cooler
Car vacuum,
air compressor
NOTE: Actual time may vary. Times are based
on the internal battery being fully charged.
7.3 Ensure that all of the jump starter
components are in place and in good
working condition.
7.4 All servicing should be performed by
qualified service personnel.
where damage could occur if the internal
battery should unexpectedly leak acid.
8.4 IMPORTANT:
• CHARGE IMMEDIATELY AFTER
PURCHASE
• KEEP FULLY CHARGED
Charge the jump starter's internal battery
immediately after purchase, after every
use and every 30 days.
All batteries are affected by temperature. The
ideal storage temperature is at 70°F. The
internal battery will gradually self-discharge
(lose power) over time, especially in warm
environments. Leaving the battery in a
discharged state may result in permanent
battery damage. To ensure satisfactory
performance and avoid permanent damage,
charge the internal battery every month.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the jump starter and
reverse the clamps.
Press the Battery Status button
on the front of the unit. The LEDs
will indicate the status of charge.
Have the battery checked.
EST ESTIMATED
WATTAGE RUN TIME
4 watts 54 hrs
4 watts 54 hrs
9 watts 24 hrs
9 watts 24 hrs
15 watts 14.4 hrs
24 watts 9 hrs
48 watts 4.5 hrs
80 watts 2.7 hrs
SOLUTION