Applications - Ryobi P2108 Manuel D'utilisation

WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
WARNING:
Never fell a tree or cut a log or limb that has a
diameter greater that the length of the guide
bar. Only properly trained professionals should
perform these cuts. Performing these types of
cuts can cause an accident and result in death
or serious personal injury.
NOTICE:
Before each use, inspect the entire product
for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely
all fasteners and caps and do not operate this
product until all missing or damaged parts are
replaced. Please contact customer service or
an authorized service center for assistance.

APPLICATIONS

You may use this product for the following purposes:
 Limbing and pruning branches from trees
 Felling small trees
 Bucking the fallen tree into shorter lengths
This product will accept RYOBI
lithium-ion battery packs and RYOBI
nickel-cadmium battery packs.
For complete charging instructions, refer to the
Operator's Manual for your RYOBI
tery pack and charger models.
OPERATION
TO INSTALL/REMOVE BATTERY PACK
See Figure 5.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands clear of
the look-out button when carrying or transporting
the tool.
To install:
 Place the battery pack in your chain saw. Align
 Make sure the latches on each side of the bat-
To remove:
Locate latches on side of battery pack and depress
both sides to release the battery pack from the
chain saw.
ONE+ 18 V
™
™
ONE+ 18 V
™
™
ONE+ bat-
™
™
16 - English
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, carrying, transporting or when
not in use. Removing battery pack will prevent
accidental starting that could cause serious
personal injury.
raised rib on battery pack with groove in chain
saw's battery port.
tery pack snap in place and that battery pack is
secured in chain saw before beginning operation.
BATTERY
PORT
LATCH
BATTERY
LATCH
Fig. 5
PACK