Warnings For Temperature Settings; Temperature Indicator - Sharp SJ-L2300E00X-EU Guide D'utilisation

CHAPTER -3: USING YOUR FRIDGE
Fridge partition temperature setting button
This button allows setting temperature of the fridge. In order to set values for fridge partition, press this button. Use this
button also to activate Super Cooling mode.
Alarm light
In case of a problem within the fridge, the alarm led will release red light
Super cooling mode
When would it be used?
• To cooling huge quantities of food.
• To cooling fast food.
• To cooling food quickly.
• To store seasonal food for a long time.
How to use?
• Press temperature set button until super cooling light comes on.
• Super cooling led will light during this mode.
• For optimal appliance performance in maximum cooling capacity, set the appliance to active Super Cooling
mode 6 hours before you put the fresh food into the fridge.
During this mode:
If you press temperature set button, the mode will be cancelled and the setting will be restored from 2.
Note: "Super cooling" mode will be automatically cancelled after 6 hours or when cooling sensor temperature
drops beneath 2 °C.
Fridge temperature settings
• The initial temperature of the Setting Display is 5°C.
• Press fridge setting button once.
• Every time you press the button, the setting temperature will increase. (2°C, 4°C, 5°C, 6°C, 8°C, super cooling)
• If you press fridge setting button until super cooling symbol is displayed on your fridge
- Settings Display and you do not press any button within the following 3 seconds,
- Super cooling will blink.
• If you keep on pressing, it will restart from last value.

Warnings for temperature settings

• The ambient temperature, temperature of the freshly stored food and how often the door is opened, affects the
temperature in the refrigerator compartment. If required,change the temperature setting.
• The temperature setting should be set by taking into consideration how often the fridge door is opened and
closed, how much food is stored in the fridge and the environment in which and the positioning of the appliance.
• We recommend that when first using the fridge it should be left running for 24 hours uninterrupted to ensure it
is completely cooled. Do not open the fridge door, or put food inside for this period.
• Your fridge has a 5 minute built in delay function, designed to prevent damage to the compressor. When power
is applied to your fridge, it will begin to operate normally after 5 minutes.
• Your fridge is designed to operate in the ambient
temperature intervals stated in the standards, according
to the climate class stated in the information label. It is
not recommended that your fridge is operated in the
environments which are out of the stated temperature
intervals in terms of cooling efficiency.
• This appliance is designed for use at an ambient tem-
perature within the 10°C - 38°C range.

Temperature indicator

In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in
the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make sure the message "OK"
appears on the temperature indicator. If « OK » does not appear, this means temperature has not been set
properly
It may be difficult to see the indicator, make sure it is properly lit.Each time the temperature setting device is
changed, wait for the stabilisation of the temperature inside the appliance before proceeding, if necessary,
with a new temperature setting. Please change the position of the temperature setting device progressively and wait at
least 12 hours before starting a new check and potential change.
NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance,
it is normal for the indication "OK" not to appear in the temperature setting indicator. If there is an abnormal build up
of ice crystals of ice crystals (bottom wall of the appliance) on the refrigerator compartment, evaporator (overloaded
appliance, high room temperature, frequent door openings), put the temperature setting device on a lower position until
compressor off periods are obtained again.
Climate Class
T
ST
N
SN
EN -6-
Ambient Temperature
Between 16 and 43 (°C)
Between 16 and 38 (°C)
Between 16 and 32 (°C)
Between 10 and 32 (°C)
OK
C
o