Fontanot genius - q 050 Instructions De Montage page 11

handrail 140053 using the parts 002031, checking that the balusters are vertical. Tighten the parts 001004 (Fig. 1).
33. Depending on the position and whether there are walls around the opening of the staircase, one or two extra
balusters 127032 or 127036 may need to be positioned.
34. In this case, allow for a space equidistant from the other balusters or from the wall. Drill a hole in the landing
using a 5 mm Ø bit and tighten the parts 033063, 001004 and 002040 (Fig. 1).
Fitting a balustrade on the floor (Fig. 11): determine the position of the balusters 127032 or 127036 on
the floor, on average one every 28 cm and at a distance from the edge of about 8 cm. In case of reinforced
concrete floors, drill a hole using a 10 mm Ø bit, fit the parts 046015 and fasten them with chemical resin
(not provided). In case of wooden floors, drill a hole using a 6,5 mm Ø bit and directly screw on the part
046015 using the two nuts 005001. Assemble the parts 033063 with the parts 009002 and 005001.
Fit the balustrade balusters (H= 910 mm) 127032 or 127036 to the parts 033063, and lock them with
the parts 001004. In case of straight balustrades, fit the reinforcement balusters 127034 or 127037
approximately every metre. Fasten the balusters to the wall using the part 033010 with the parts 031059
008004, 011053, 033056, 011057 and 005035 (drill a hole using an 8 mm Ø bit). Determine the length of
the handrails and cut off the excess. Assemble the straight handrails 140053 to the balusters with the parts
002031 joining them with the parts 031076 and 046011 for the straight balustrades. Assemble any joining
parts 033164, 033163, 033162 and end parts 033164 (Fig. 11).
35. Determine the length of the rods 076059 (Fig. 10) based on the staircase dimensions and cut them.
Assemble the rods 076059. In correspondence to the corner balusters, use the parts 001011, 011069,
033160, 033161. Bend the rods to facilitate their intersection in correspondence to the corner treads.
Finally, tighten the parts 001011 previously fitted in the parts 034040 of the intermediate balusters (y).
36. Complete the railing assembly by fitting the parts BF2 to the lower part of the balusters 127031 or 127035
and the parts 004051 to the sides of the treads (Fig. 1).
11 - Genius 050 - 060 Q