Instructions For Use; Fluid Dispensing - Mityvac MV6400 Mode D'emploi

instruCtions for use

fluid dispensing

1. Unscrew the lid w/ pump from the reservoir,
and fill to desired level with clean fluid.
note:There are two scales of volume on the
reservoir. One scale indicates the volume
when the lid w/ pump is removed and one
when the lid w/ pump is installed. Be sure to
note the appropriate scale.
Caution: If fluid is added above the MAX
FILL line, the reservoir will overflow when the
lid w/ pump is installed.
2. Reinstall the lid w/ pump onto the reservoir.
3. Connect the fluid dispensing hose or other
accessory to the quick-connect coupler ex-
tending from the reservoir. Ensure the coupler
sleeve snaps forward to lock the
connection.
note: Depending on the application, the
shutoff valve installed in the fluid dispensing
hose may be left open or closed. If left open,
fluid will begin to flow as soon as the pump is
operated. If closed, pressure will build in the
reservoir as indicated on the gauge.
4. While observing the pressure gauge, operate
the pump to build pressure in the reservoir to
the desired level, or until the desired amount of
fluid has been dispensed.
note: A built-in pressure relief valve is de-
signed to open and maintain maximum pres-
sure between 17 and 23 psi (1.2 and 1.6 bar).
Continual operation of the pump is not re-
quired to maintain fluid flow. Fluid will continue
to flow as long as there is pressure in the
reservoir and the shutoff valve is open.
Warning: Do not exceed 25 psi (1.7 bar)
pressure in the reservoir. The relief valve
should prevent this, but if it fails and the pres-
sure exceeds 25 psi, immediately discontinue
use and send the unit to an authorized service
center for repair or replacement.
5. Once the proper amount of fluid has been dis-
pensed, close the shutoff valve and bleed off
the pressure by tilting the pressure relief knob
located on the lid.
Form 801193
6. Depending on the type of fluid and future
intended use, you may store the remaining
fluid from the reservoir. Otherwise empty the
reservoir, clean it with denatured alcohol or
a common household cleaner, and store it
properly.
Page Number - 5