In Combination With Building-In Oven Or Control Panel; In Combination With Building-In Oven - Pelgrim GKV 120-125 Notice D'utilisation

The minimal panel thickness in
combination with a built-in oven is 30 mm.
The maximal panel thickness is 60 mm.
4 9 0
A
1 0
m i n m i n
. .
Detail A
Please note:
The area to be cut away at the front is
measured from 10 mm from the body of the
cupboard (cupboard front without door).
In combination with building-in oven or
control panel
Remove the saucepan supports and the
burner caps.
Unscrew the assembly plate behind the
control panel. Only unscrew the top and
bottom screws (fitted every other one)
(see fig. 4 and 5).
Position the cardan joints (see fig. 6) in
sequence over the shafts of the taps of the
hob. Slide the joint approximately 10 mm
over the shaft and screw tight.
fig. 3
Install the hob, screw the assembly clamps
tight. If the unit is constructed from thin
material turn the assembly clamps round.
Connect the hob to the gas supply and test
fig. 4
to ensure that there are no gas leaks.
Insert the plug of the hob (if present) into
the wall socket.
After having inserted the plug of the oven
into the wall socket, the oven can be
inserted two-thirds of the way into the
cupboard.
fig. 5
Reattach the assembly plate to the control
panel.
Screw the oven to the kitchen cupboard.
Replace the control knobs.
Replace the saucepan supports and the
burner caps.
fig. 6
After installation check that the appliance
and the burners are working properly; the
gas flames should be regular and stable
when full on and the burners should not go
out when turned to the lowest setting.

In combination with building-in oven

Remove the saucepan supports and the
burner caps.
Remove the control knobs for the burners
fig. 7
on the control panel.
Unscrew the four cardan joints from the
control panel.
Position the cardan joints over the shafts of
the taps of the hob. Slide the joint
approximately 10 mm over the shaft and
screw tight (see fig.6).
Install the hob, screw the assembly clamps
tight. If the unit is constructed from thin
material turn the assembly clamps round.
Connect the hob to the gas supply and test
to ensure that there are no gas leaks.
Insert the plug of the hob (if present) into the
wall socket.
fig. 8
After having inserted the plug of the oven
into the wall socket, the oven can be
inserted two-thirds of the way into the
cupboard. Take care with the cardan joints;
lift these a little.
Slide the oven further into the cupboard so
that the cardan joints can be mounted on
the control panel. Pay attention to the
OFF position while doing so.
Now slide the oven completely into the
cupboard and screw it tight. Assemble the
control knobs.
Replace the saucepan supports and the
burner caps.
After installation check that the appliance
and the burners are working properly; the
gas flames should be regular and stable
when full on and the burners should not go
out when turned to the lowest setting.