Appliance Information; Before Using The Appliance; Things To Watch For; Lighting The Burners - Pelgrim GKV 120-125 Notice D'utilisation

Introduction
When you have read these instructions for
use, you will quickly be aware of all the
facilities the appliance can offer you. You can
read about safety and how you should look
after the appliance. In addition you will find
environmental tips and instructions that can
help to save energy.
Keep the instructions for use and the
installation instructions. Any later user of this
appliance could benefit from them.
Enjoy your cooking!

Appliance information

1 - control knob for semi-rapid burner 1
2 - control knob for rapid burner 2
3 - control knob for lsimmer burner 3
4 - control knob for semi-rapid burner 4
5 - enamelled saucepan supports
6 - enamelled or stainless steel drip tray
Control knob symbols:
0 off
spark switch
high
low
Table of contents
Appliance information . . . . . . . . . . . . . . . . 8
Disposal of packaging and appliance . . . 8
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Before using the appliance . . . . . . . . . . . . 9
Things to watch for . . . . . . . . . . . . . . . . . . . 9
Operating the appliance . . . . . . . . . . . . . . 9
Lighting the burners . . . . . . . . . . . . . . . . . . 9
Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Saucepans . . . . . . . . . . . . . . . . . . . . . . . . . 10
Maintenance . . . . . . . . . . . . . . . . . . . . . . . 10
Cleaning the appliance . . . . . . . . . . . . . . . 10
Installation . . . . . . . . . . . . . . . . . . . . . . . . 11
Assembly . . . . . . . . . . . . . . . . . . . . . . 11 - 12
In combination with building-in oven
or control panel . . . . . . . . . . . . . . . . . . . . . 12
In combination with building-in oven . . . 13
Technical specifications . . . . . . . . . . . . . 11
Packaging and appliances
The packaging of the appliance is recyclable.
It is made up off:
- cardboard
- polyethylene
- CFC free polystyrene (PS rigid foam)
- polypropylene straps around the box
Please dispose of these materials in a
responsible way in accordance with the
regulations of your local authority.
Your local authority will also be able to give
you information about disposing disused
household appliances in a responsible way.
This appliance complies the regulations concerning
electromagnetic compatibility in directive 89/336/EEC.

Before using the appliance

The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
During repair and cleaning the appliance
needs to be disconnected from the power
supply (electricity and gas). Remove the
plug from the wall socket or turn the switch
in the metre cupboard to zero (for gas hobs
with a spark switch). Turn off the gas tap in
the feeder pipe.
This cooking appliance is designed for
household use. It should only be used for
preparing meals.
When boiling and frying the hob gets hot.
Please pay close attention to small
children.
Grease and oil are flammable when over-
heated. Stay near the appliance when
preparing dishes.
Do not use the appliance to heat the
kitchen. This will produce a damp
atmosphere.
When a gas cooking appliance is being
used heat and moisture is produced in the
area where the appliance is situated. Make
sure that the area is sufficiently ventilated;
open natural ventilation openings or fit a
mechanical ventilator (extractor). When the
hob is used for longer periods extra
ventilation may be needed, such as an open
window or a higher setting on the ventilator
(extractor).

Things to watch for

Clean immediately
Any spillage should be removed immedia-
tely, particularly red cabbage, apple sauce
and rhubarb. These can leave permanent
spots on the enamel or on stainless steel.
Burning in of the enamel
The burners cause the saucepan supports
to get extremely hot. Over time the enamel
on the support points can burn in. This
cannot be prevented and is not covered by
the guarantee.
Burner caps
Check regularly whether the caps of the
burners are properly in position on the
burner depressions; improper positioning
can make it difficult to light the burners,
give rise to an irregular gas flame, or
damage the burner caps.

Lighting the burners

While keeping the knob of the burner held in,
turn the knob to the left and light the burner
with a match. The gas flame can be smoothly
adjusted from high to low.
Using the electrical spark switch
(GKV125/GKB235)
Press the knob of burner in and turn it to the left
to the -symbol. The spark switch will
generate sparks and the burner will light
automatically. If the burner fails to light after
repeated attempts, check to ensure that the
burner cap is properly positioned. The gas flame
can be smoothly adjusted from high to low.