Antari AF-4 Mode D'emploi page 9

UP: Pair
DOWN:Del
Step 4A: Press [UP] to pair a new transmitter; press any button on the W-2 remote to finish
pairing.
Step 4B: Press [DOWN] button to delete an existing transmitter.
Transmitter battery replacement
If the effective distance seems to decrease, it is possible the battery level is low and
requires replacement. In order to replace the battery, undo the three screws on the back of
transmitter to release the cover. Replace with same type and specification of battery which
is 27A 12V
Z-3 Remote Control Operation (Optional)
To operate the machine by remote control, connect the remote to the microphone jack
located on the rear of machine. Use the switch to turn wind on/off, and use the rotary knob
to adjust the output volume from 0~100%.
DMX Connector Pin Assignment
The machine provides 5-pin XLR connector for DMX connection. The diagram below
indicates pin assignment information.
Z-3 Remote (Optional)
9