Publicité
Les langues disponibles
Les langues disponibles
Connect the battery pack to the charging lead. The green LED (Trickle) will illuminate. The
charger is now in the trickle charge mode. To start the fast charge process, push on the
yellow 'Start' button till the red LED 'Fast' illuminates. You will hear a short beep signal as
well . The fast charge sequence started. The charging time will be between 25 and 60 minu-
tes depending on the capacity of the battery pack. Approx. 1 min. before the fast charging
sequence will be ended there will be a continious beep signal to indicate the end of the
charging process. The charger will switch automatically into the trickle charge mode to keep
the battery tension at level.
When a battery is fully charged
Safety notes:
-
Place the charger on a firm, level surface for charging.
-
Do not cover the ventilation slots.
-
Take care over battery polarity, and observe the manufacturer's recommendations. Avoid
short circuits.
-
NC cells become warm when charged. If the pack feels hot, disconnect the battery
-
Be sure to set the correct charge current to suit the capacity of the NC pack.
-
Do not exceed the recommended charge period.
-
Always plug the charge lead into the charger first, then connect the battery.
-
If the mains supply fails or you disconnect the mains plug, always disconnect any
batteries from the charger, as they may discharge themselves.
-
If batteries are overcharged they become very hot. For this reason it is always best to
place the pack on an insulated, heat-resistant surface for charging.
-
The charger must only be used in dry conditions.
Technical specifications:
Input voltage:
No. of battery cells: Fast charge output: 6 to 8(*) NiCad or NIMH cells
Charge current:
We reserve the right to alter technical specifications. We accept no liability for incorrect in-
formation, printing errors, misuse of the charger and any damages caused by the unit.
(*) 8 cells must be charged only using the mains supply
1. first disconnect the battery from the charging lead
2. disconnect the charging lead from the charger
3. disconnect the charger from the mains or 12V supply
240 V / 50 Hz mains supply
or 12V DC supply
RX output:
TX output:
Fast charge: 3000 mA
RX output:
150 mA
TX output:
150 mA
from 1300 mAh to 3000 mAh
4 to 5 NiCad or NIMH cells
from 270 mAh to 2400 mAh
6 to 8 NiCad or NIMH cells
from 270 mAh till 2400 mAh
Publicité
