Cleaning; When The Appliance Is Not In Use; How To Change The Bulb - Kuppersbusch IKE 166-0 Mode D'emploi

GB
Melting water flows through defrost water outlet into
the evaporative tray maintained on the top of
compressor and evaporates due to warmth of it.
Check and clean the outlet of melting
water coming during defrosting regularly. If
it is clogged the melting water gathered can
cause earlier failure as it can go to the insulating
of the appliance.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe
scraper has to be stored in the outlet.
Occasionally check the defrost water outlet not to be
clogged up.
The most typical case of clogging up in the defrost
water outlet when you put food wrapped in some
paper into the appliance and this paper contacts back
plate of cooling compartment and freezes to it. If you
remove the food right at this moment the paper will
tear and it can cause clogging up in the outlet by
getting into it. So you are asked to be careful -
because of the above - when placing foods wrapped
in paper into the appliance.
In case of increased demand e.g. during
heatwaves, the refrigerator temporarily happens
to operate constantly - during this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on back plate of
the cooling compartment after defrosting period is not
abnormal.

Cleaning

Never use metal objects for cleaning your
appliance as it may get damaged.
NEVER use detergents, abrasive powders, highly
perfumed cleaning products or wax polishes to
clean the interior as these will damage the
surface and leave
Metallgegenstände um das Gerät zu reinigen, da
es beschädigt werden könnte.
20
a strong odour.nie
Clean the inside with warm water and bicarbonate
of soda. Rinse and dry thoroughly.
To guarantee a safe operation of the fridge, once a
year remove the ventilation grill at the base and
clean the air channels with a vacuum cleaner.

When the appliance is not in use

Disconnect the appliance from the electricity
supply.
Empty all foods and clean the appliance, leaving
the doors ajar to prevent unpleasant smells.

How to change the bulb

Should the light fail to work you can change it as
below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then
take the lamp cover off in the direction of arrow and
the bulb can be changed. (Type of the bulb:
Mignon 322, 230 V, 15 W, E 14 thread)
After changing bulb replace the lamp cover, screw
the plate screw and apply voltage to the appliance.
The lack of light does not influence operation of the
refrigerator.