Something Not Working - Kuppersbusch IKE 166-0 Mode D'emploi

Something not Working

Problems may be due to causes which can easily
be solved before calling the Technical Service.
Please follow these instructions:
SYMPTOM
Door does not close
It is too warm inside the refrigerator
It is too cold inside the refrigerator.
The compressor works continuously.
There is water inside/outside the
refrigerator.
Water comes out on the floor.
Noises
Level properly the appliances if it is not well levelled.
Weight surpasses the storage limit of the door shelf so spread
weight more evenly or take some products out.
The appliance is not properly installed. Please look in the "Building-
in" section.
Set a lower temperature.
Distribute the food products to allow cold air to circulate around
them.
Make sure that the door is completely closed and that the insulating
strip is complete and clean.
The temperature where the cabinet is placed is above normal room
temperature.
Turn the temperature regulator to a warmer setting temporarily.
Turn the thermostat knob to a lower number.
The temperature where the cabinet is placed is above normal room
temperature.
Check that the ventilation is sufficient and that the ventilation
openings are unobstructed.
The cause could be the introduction of large quantities of food
and/or frequent opening/closing of the door.
Sometimes is normal. During automatic defrosting frost thaws on the
cooling plate.
Place the drain hose at the back of the cabinet above the drain bowl.
Sometimes this is normal. Temperature control may cause clicking
sounds when the system is connected or disconnected.
The injected cooling gas may produce a gurgling sound while
passing through the tubes.
The motor may cause a humming noise and/or slight bumping.
The insulation material used has a tendency to slighly increase noise
levels, how ever it allows for much better insulation and a lower
energy consumption.
SOLUTION
GB
21