Maintenance And Cleaning - TEFAL FV5735 Mode D'emploi

Obtain more steam
Superpressing
• Press the
stubborn creases (
Vertical steam ironing
Ideal for removing creases in suits, jackets, skirts, curtains, etc. :
• Hang the garment on a hanger and hold the fabric slightly taut
with one hand.
• Set the thermostat control to
Superpressing
• Press the
the iron from top to bottom (fig 10).
• Hold the iron a few centimetres from the fabric to avoid burning
delicate fabrics.

Maintenance and cleaning

Cleaning the anti-calc valve
• Unplug your iron and empty the water tank.
self-clean
• Press the
anti-calc cartridge (
• Soak the valve in a cup of white spirit vinegar or plain lemon
juice for 4 hours.
• Rinse the valve under running water and Replace the anti-calc
valve.
Carry out the self-cleaning operation
To slow down scaling and
prolong the useful life of
your iron, carry out the
self-cleaning operation
once a month.
4
(according to model)
button now and again to remove
fig 7
).
• Whether steam or dry ironing, you are able to use the
button
(according to model)
fig 9
MAX
(
button repeatedly (
• Set the steam control to
• Wait until the soleplate cools down and empty the reservoir.
A little water may remain in the reservoir.
• Wind the cord around the heel of the iron.
• Store the cold iron on its heel (
ejection button (
fig 12b
)
• Unplug your iron, set the steam control to
water reservoir to MAX.
• Place your iron on its heel, set the thermostat button to MAX,
plug in your iron and wait for the indicator light to go out.
• Unplug the iron and place it horizontally over a sink.
• Press the self-clean ejection button (
anticalc cartridge (
• Gently shake the iron over the sink until some of the water
(along with impurities) runs out through the soleplate.
• At the end of the operation, put the anticalc cartridge back in
place and then plug in your iron for 2 minutes on its heel to dry
the soleplate.
fig 8
( ) to dampen laundry to remove stubborn creases.
).
fig 7
) moving
(once a month)
fig 12a
) and remove the
fig 12b
).
Wait a few seconds
between each shot before
pressing the button again.
Spray Function
Every fifth time you press
the button, return the iron
to the horizontal position.
The steam is very hot, so
you should always do this
with the garment on a
hanger – never while
someone is wearing it.
Store your iron
and unplug the iron.
fig 11
).
Unplug your iron and let
it cool down before clean-
ing it.
The iron will not function
without the anti-calc
valve. Never touch the
end of the valve !
(once a month)
fig 12a
) and remove the
Spray
and fill the