Installation Instructions; Technical Data; Symbol Description - Hansgrohe M7117-H240 73817000 Mode D'emploi / Instructions De Montage

Safety Notes
Gloves should be worn during installation to prevent crushing and cutting
injuries.
The hot and cold supplies must be of equal pressures.

Installation Instructions

Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
The pipes and the e must be installed,
ble standards.
The plumbing codes applicable in the respective countries must be observed.
During initial start-up and after servicing, air in the
switching the jet on and about 15 times, the noise will stop.

Technical Data

Operating pressur
Recommended operating pressur
Test pressur
Hot water temperatur
Recommended hot water t
Thermal disinf
The product is exclusively designed for drinking water!
Fault
Mixer s
Mixer dripping
Low w with Select valve after valve replacement
Water escaping in area of swivel spout
Water escaping at the threaded base
Hot water temperature too low
Select button s
4
English
and tested as per the applica-
can cause noise. After
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
65°C
max. 70°C / 4 min
Cause
Cartridge defective,
Cartridge defective
Improper Select valve installed
O-ring defective
connection hoses not completely screwed into basic
body
O-ring at the connection hose defective.
Hot water limiter incorrectly set
Select button soiled
Assembly (see page 32)

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 36)
To adjust the hot water limiter. Using a hot water limiter in combination
with a continuous w water heater is not recommended.
Operation (see page 37)
Hansgrohe recommends not to use as drinking water the st half
liter of water drawn in the morning or after a prolonged period of
non-use.
Minor leaking may occur br
via the lever.
Use the lever to open the tap and set the desired temperature. The
water w can be paused by pressing the Select button on the face
side of the spout. When the tap is not used for a longer period of
time, f.e. when retiring at night or leaving the house, it must be closed
completely by means of the lever.
Cleaning (see page 39)
Maintenance (see page 37)
The check valves must be checked regularly according to DIN
EN 1717 in accordance with national or regional regulations (at least
once a year).
Dimensions (see page 31)
Flow diagram (see page 31)

Normal spray

Regular
Spare parts (see page 38)
= Colors
= chrome plated
= stainless steel optic
Special accessories (order as an extra)
F12 extension #43333000 (see page 36)
Test certificate (see page 40)
Remedy
Exchange cartridge
Exchange cartridge
Replace Select valve #98463000 (see page 38)
Exchange O-ring
Tighten connection hoses by hand
Exchange O-ring
Set hot water limiter
Clean Select button and grease (14x1,5) O-ring
(see page 38)
at the spout when opening the