Functions And Description; Installation And Operation; Storage; Warnig Against Hazardous Operations - Tractel pakrol Notice D'instruction

1. FUNCTIONS AND DESCRIPTION

The PAKROL™ range has been designed to handle and move loads on the floor. The
moving of the skate and trolley skate is done manually by the operator at a very slow
speed (< 5 km/h). The floor shall be flat and resistant to the load applied. To make the
moving in a safe condition, the floor shall be built with concrete or tiled. Clay floors are
inapropriate.

2. INSTALLATION AND OPERATION

TO OFFER THE BEST LOAD STABILITY AND MAKE ITS GUIDING EASIER , WE
RECOMMEND TO SHARE THE LOAD SURFACE ON TWO SKATES AND ONE
TROLLEY SKATE FOR GUIDING.
Prior to place the PAKROL™ skates under the load, check that the product you have
received is in a good order mainly for the running wheels. Then fit the handle to the trolley
skate with the two bolts. As an option, we can supply the connecting bar between the
two skates, if our supply includes this equipment, then you need to bolt this connecting
bar to the frame of each skate.
INSTALLATION OF THE PAKROL™ SYSTEM
• With a rack and pinion or hydraulic jack, lift the load to a sufficient height to be able to
position the skates and trolley skates.
• Secure the load with wedges to prevent any fall of the load when positioning the
PAKROL™.
• Place the skates and trolley skate in such a way that the load is correctly positionned
in full stability. (We advise you to use a connecting bar between the two skates to ensure
a reliable guiding when moving).
• Remove the wedges and lower the load to be positionned on the skates and trolley
skate. Before moving, ensure that the load is well balanced.
• The guiding of the load will be done with the handle of the trolley skate.
• To remove the PAKROL™ system after moving the load, lift the load with jacks and
secure with wedges.

3. STORAGE

When storing the PAKROL™ system, we recommend to place them in the original
packing. In any case, the skates and trolley skates shall be stored upside down on the
rubber cover without load. During transport operation, we recommend the operator to
use the manipulating handle.
4. WARNING AGAINST HAZARDOUS OPERATIONS
Warnings against hazardous operations have been described in the previous sections,
however, we would draw your attention to certain operations which are dangerous:
• DO NOT USE the PAKROL™ products over their Working Load Limit or without their
identification load plate.
• DO NOT MOVE loads with people on.
7
GB