Connect Electric; Install Chimney - Bosch DKE96 Mode D'emploi

6) Connect to Ductwork

7) Connect Electric

8) Install Chimney

English 6
Note: Be sure that the glass screen is not touching the back wall.
Install two lower hood screws from underneath.
Connect hood to ductwork in house.
Plug electrical cord into grounded outlet. Note: The hood requires a 120V AC,
60Hz., 15A Branch Circuit.
Remove protective film from both sections of chimney.
Connect the sections, one inside the other. For recirculation, the slots in the upper
chimney section should be at the end closest to the ceiling. When venting to the
outside, the top section can be turned upside down to conceal the vents.
CAUTION: Be careful not to scratch chimney surface when connecting. Slide tem-
plates between the two chimney sections to protect them.
1/4"
Figure 6:
Hang the Hood
Figure 5:
Install Lower Hood Screws