Operating Instructions; Overview; Prior To Starting Up; Charging The Battery - APA 20992 Manuel De L'opérateur

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1 ON/OFF switch
2 Guide handle
3 Battery compartment
4 Polishing plate
5 Battery
6 Unlocking button
7 Contact surfaces
8 Charging socket
9 Charger
10 Charge control lamp
11 Coaxial connector

6.2 PRIOR TO STARTING UP

6.2.1 CHARGING THE BATTERY

The battery (Position 5 in the overview) must be removed from the device to charge it. To do this, press the
unlocking button (Position 6 in the overview) and pull the battery pack out of the polishing machine. Plug the
coaxial connector (Position 11 in the overview) into the charging socket (Position 8 in the overview) of the battery
pack. Plug the charger into a mains socket. The charge control lamp (Position 10 in the overview) is lit in red during
the charging process. When the battery pack is charged, the charge control lamp lights in green. After charging,
remove the charger from the socket and then disconnect the battery pack from the charger.

6.2.2 MOUNTING THE POLISHING HOOD

Always first remove the battery pack from the device before attaching or removing the polishing hood.
Unintentional activation of the device may result in injuries or damages to the device or vehicle.
Attach the appropriate polishing hood for your application to the polishing plate (Position 4 in the overview). Make
sure that the polishing plate and hood are free from dirt.
Woven hood:
Terrycloth polishing hood:
Align the polishing hood centrally on the polishing plate. Replace the battery pack

6.3 POLISHING

Carefully clean the surface you wish to polish. The surface must be completely dry before polishing. Only
use polishing and waxing products designed for use with polishing machines. Observe the instructions
for the care products being used. Heavily weathered paintwork may require special pre-treatment. For
information, inquire at the specialist dealership.

6.3.1 APPLYING CARE PRODUCT TO THE POLISHING HOOD

First attach the woven hood. Apply the care product evenly up to the edges. A continuous, thin coating must be ensured.
Applying excess care product will not improve the results, it will just make it more difficult to remove.
Polishing too long on the same spot may damage the varnish.
Do not polish the vehicle in full sunlight or in very high temperatures.
8
For applying polishing or wax and for polishing
For polishing to a shine