Disposal And Recycling - Ergo tools Pattfield E-ET30 Mode D'emploi D'origine

Anleitung_E_ET_30_SPK7:_
immediately after you use it.
Clean the tool regularly with a moist cloth and
some soft soap. Do not use cleaning agents or
solvents; these may be aggressive to the tool's
plastic parts. Ensure that no water can get into the
interior of the tool.
Maintenance
There is a risk of staples becoming jammed
particularly when the electric stapler is held at any
angle when operated. In this case, switch the tool
off immediately and pull the power plug.
Important. Always pull the plug out of the
power socket before doing any work on the
electric stapler!
Removing jammed staples (Fig. 2/3/7)
Pull the magazine slide (4) to the rear as far as the
stop (Fig. 2/3). Carefully remove the jammed staples
with a pair of pliers. Push the magazine slide (4)
back in until it stops and snaps noticeably into place.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to the
raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
16.07.2009 8:36 Uhr Seite 11
GB
11