Cleaning, Maintenance And Ordering Of Spare Parts - Ergo tools Pattfield E-ET30 Mode D'emploi D'origine

Anleitung_E_ET_30_SPK7:_
GB
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Vibration emission value a = 7.8 m/s 2
h
K uncertainty = 1.5 m/s 2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
5. Starting up
Inserting the staples (Fig. 2-4)
Switch the tool off and pull the power plug.
Press the lever (a) on the magazine slide (4)
downwards (Fig. 2).
Pull the magazine slide (4) to the rear as far as
the stop (Fig. 3).
Fill the magazine with staples or nails (Fig. 4).
When you fill the magazine with nails, make sure
that these rest against the left inner side (b) of
the magazine.
Then slide the magazine slide back in until it stops
and snaps noticeably into place.
Important!
It must be possible to move the magazine slide
without applying much force. Watch out for jammed
staples and nails.
6. Operation (Fig. 1/5/6)
Before starting your work, always check the filling
level indicator (6) to see if the magazine (5)
contains staples or nails and is properly closed with
the magazine slide (4).
10
16.07.2009 8:36 Uhr Seite 10
6.1 Switching on the electric stapler
Switch on the electric stapler using the On/Off switch
(2) (switch position I) directly before starting work.
The tool is now ready for operation. If the electric
stapler is no longer in operation – even for short
periods – switch off the tool with the On/Off switch
(switch position 0) to prevent unintentional operation.
6.2 Triggering
The built-in trigger lock prevents the electric stapler
from being triggered accidentally.
Triggering is only possible as follows: Press the head
of the electric stapler against the material and operate
the trigger.
The control lamp (3) shows you when you can trigger
a shot.
6.3 Inserting staples
Fill the staples into the magazine as shown in Fig. 5.
6.4 Inserting nails
Fill the nails into the magazine as shown in Fig. 6.
6.5 Stapling textiles, materials, leather, etc.
Press the head of the electric stapler against the
object where you want to staple and operate the
trigger.
6.6 Stapling wood strips
Use only nails to staple wood strips. Do not press
the electric stapler too firmly against the wood strip
or you might damage the surface.
6.7 Filling level indicator (Fig. 1)
The filling level indicator (6) shows you if there are still
enough staples or nails in the magazine (5). If
necessary, refill the magazine (5) as described
above. Avoid operating the trigger (1) if there are no
staples or nails in the magazine (5).
7. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before
starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the housing
free of dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it with
compressed air at low pressure.
We recommend that you clean the tool