Software Update - Ltc Audio VP2000 Manuel D'utilisation

ENGLISH
Caution:
1. The USB interface supports USB1.1, USB2.0 including hard drives and flash drives.
2. Supported max. storage: 400GB
3. Supported system format: FAT16, FAT32, NTFS
4. The USB interface can support most drives but is not universal. Any unknown device problem is caused by
the device drive.
5. The total current of the connected devices should not exceed 1200mA. The problems caused by incorrect
operations are not covered by the warranty.
Multimedia Format
Function
MOVIE
MUSIC
PICTURE

7) SOFTWARE UPDATE

If the software needs to be updated, you can update the system through USB.
INSTRUCTIONS FOR CONNECTION TO A PC
1. Connect to a PC via HDMI:
Connect the projector and the device via the HDMI cable. Press "Source" on the remote control and choose
"HDMI-1" as input source (picture1)
2. Connect to a PC via VGA:
Connect the projector to your device via the VGA cable. Press "Source" on the remote control and choose
"VGA" as input source (picture 2)
Picture 1
Recommendations:
Adjust the PC/laptop display resolution to about 1024 x 768 or a little higher which can improve the sharpness.
If the screen doesn't display properly after connection, please set your PC from "Multiple display" to "Duplicate
these displays".
Please check the screenshot:
8
Format
.avi
.mpg
.dat
.mp3
.m4a/.aac
.jpg/jpeg
.bmp
Picture 2
© Copyright LOTRONIC 2019
Video Decode
MPEG-4
MPEG-1, MPEG-2
MPEG-1
--
--
Progressive JPEG
Baseline JPEG
BMP
Audio Decode
MP3, AAC
MP3
AAC
--
--