Installation Method - Ltc Audio VP2000 Manuel D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

ENGLISH

RECOMMENDATIONS FOR BATTERIES

This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in

accordance with your local regulations. Batteries shall not be exposed to excessive heat such as sunshine, fire or the

like.

When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.

ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.

WARNING: Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.

If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.

If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-

diately a doctor.

TURN THE PROJECTOR ON/OFF

To turn on the projector, connect the power cable and press the power key on the back board or the top panel. It

will take a couple of minutes for the lamp to start operating.

If you switch it on with the switch on the back board, the indicator light will turn red.

If you switch it on via the remote control or the top panel, the indicator light will change to blue.

After a few seconds, the lamp will begin to work.

If you use the projector for the first time, the image may appear blurry or distorted. Refer to the image adjust-

ment chapter for instructions.

You may also reset the system parameters anytime. Please refer to the Menu Setting chapter.

While using the projector, press the power key to enter standby mode.

When the projector is in standby mode, its auto protecting system will be activated. Press the power key to start

up again.

INSTALLATION

(see. fig. 4)

Standard setting

Please refer to following table to adjust your picture size and distance (from the lens to the screen):

Picture

4 : 3

50"

2.3m

70"

3.1m

80"

3.5m

100"

4.3m

We recommend not to exceed 80" for a better picture.

Please allow±3% to the image sizes above. If the distance is below the minimum or above the maximum, the

image could be blurry.

Please check the diagram below for trapezoidal adjustment.

Incorrect installation