Set Temperature; Timer Switch - Sonnenkonig STOCKHOLM Mode D'emploi

• Press the UP or DOWN keys to move the cursor to the corresponding day,
press the "+" to add the corresponding day, or press "-" to delete the day
until you have completed the selection of all dates
• Continue to press the " TIMER SET" button, the hour starts blinking
• Press the "+" or "-" to adjust the hour
EN
• Continue to press the " TIMER SET" button, the minute starts blinking
• Press the "+" or "-" to adjust minute
Set the shutdown time
• Then press the "TIMER SET" button, the display is off, and the hour starts
blinking
• Press the "+" or "-" to adjust the hour�
• Continue to press the " TIMER SET" button, the minute starts blinking
• Press the "+" or "-" to adjust minute

Set temperature

• Then press the " TIMER SET" button, and the temperature set starts blin-
king� At this moment, the temperature displayed is the normally set tempe-
rature, which can be adjusted by pressing "+" or "-"
• Press " TIMER SET" button to continue setting, and press "OK" complete
the setting

Timer switch

• "TIMER ON/OFF" is to control the timed opening and closing
• Restart the machine after power is cut off, the timer setting is kept, but the
current date and time must be reset
• NOTE 1: Press the 1000W button or 2000W button, or IC button to active
the heating when timer ON after finish a timing setting� The heater only has
flame effect working if you have not selected the desired heating�
• NOTE 2: Repeat the same procedures to set more timing cycles if required
after the first timing cycle is finished�
42