Operation - Sonnenkonig STOCKHOLM Mode D'emploi

2 Operation

1 2 3 4
EN
10
Manual Operation
This is done by operating the switches located at the front of the fi re �The
standby rocker switch must fi rst be switched on, the fi re will beep to indicate
that it is powered up�
Press the O/I button once to turn the heater and fl ame eff ect on� A red indi-
cator light will appear to indicate that the function is ON� Press the O/I button
for 3 seconds this will operate the fl ame brightness setting� Hold the button
down until the desired fl ame brightness is obtained and there will be 5 levels
fl ame brightness available�
Press the POWER button once for the low heat setting 1000W; press twice for
the high heat setting 2000W; press three to switch off the heat setting�
Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors
available�
Remote Operation
The standby rocker switch located at the front of the fi re must fi rst be
switched on; the device will beep to indicate that it is powered up�
It takes a little time for the receiver to respond to the transmitter� Do not
press the buttons more than once within two seconds for the fi re to operate
normally�
5
1� Day display
2� Timer
6
3� Standby
4� Temperature
7
5� Time OFF
6� Time ON
7� Time Display
8
8� Automatic Heating
9� Flame Brightness
10� Heat Level (1 or 2 kW)
9
40