Temperature Setting; Timer Setting - Sonnenkonig STOCKHOLM Mode D'emploi

Automatic heating
Press "IC" button on the remote controller to start or exit the automatic heat-
ing�
The heater displays AUTO symbol at automatic heating status� The heater will
adjust the heat settings between 1000W and 2000W automatically according
to the room temperature and temperature setting� During a timed starting
process, it is possible to start heating ahead of schedule�
Setting the day and time
1� Settings are done on the remote controller
2� Press "DATE TIME" button, then press the UP or DOWN key to select the day
3� Press "DATE TIME" button again, then press the "+" or "-" to set the hour
4� Press "DATE TIME" button again, then press the "+" or "-" to set the minute
5� Press "OK" button to complete

Temperature setting

The default set temperature is 20º C, press "+" or "-" on the remote controller to
set the temperature, which ranges from 15 to 30º C� And this setting is only for
the temperature in the normal mode, not for the temperature in the timer mode�
NOTE: The set temperature must be higher than the room temperature for
the heater to be working.

Timer setting

There are up to 10 items for timer setting, Each setting item has its date, pow-
er-on time and shutdown time� The max� duration of each setting item is 23
hours 50 minutes� The setting date for each item can be any day or days of a
week� The date in each setting item represents the date of power-on time� If the
shutdown time of the setting falls on the second day, it is unnecessary to set
the date – you just set the shutdown time
Steps to view the timer setting
• Press the "TIMER SET" button
• Press the "+" or "-" to check the power-on time of the timer one by one�
• For checking the shutdown time, press the UP button
• Press the "+" or "-" to continue viewing
• For deleting the current item of setting, press "C" to delete
Steps for timer setting
• Press the "TIMER SET" button, and the serial number starts blinking
• Press the "+" or "-" to change the serial number until you get the serial
number that you need to set or modify�
• Press " TIMER SET" button once again, and the cursor on the left side of day
starts blinking
41
EN