Zanussi ZFC21400WA Notice D'utilisation page 16

Climate
Ambient temperature
class
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be
guaranteed within the specified
temperature range. If you have any
doubts regarding where to install the
appliance, please turn to the vendor,
to our customer service or to the
nearest Authorised Service Centre.
The plug should be accessible after
installation.
ELECTRICAL CONNECTION
• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
OPERATION
CONTROL PANEL
1 2
1
0 2
7 3
6 4
5
1
0
7
6
5
16
3
2
A
B
3
4
C
• The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
VENTILATION REQUIREMENTS
The airflow behind the appliance must be sufficient.
1. Put the freezer in horizontal position on a firm
surface. The cabinet must be on all four feet.
2. Make sure that the clearance between the
appliance and rear wall is 5 cm.
3. Make sure that the clearance between the
appliance and the sides is 5 cm.
Temperature regulator
1
Power indicator light
2
High temperature alarm light
3
A. Temperature Regulator
B. Half Loaded position
C. Full Loaded position