46
www.aeg.com
Problem and alarm code
The programme lasts too
long.
The remaining time in the
display increases and skips
nearly to the end of the pro-
gramme duration.
Small leak from the appli-
ance door.
The appliance door is diffi-
cult to close.
Rattling or knocking sounds
from the inside of the appli-
ance.
The appliance trips the cir-
cuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
12.1 The washing and drying results are not satisfactory
Problem
Poor washing results.
Possible cause and solution
• If the delay start option is set, cancel the delay setting or
wait for the end of the countdown.
• Activate the TimeSaver option to reduce the pro-
gramme duration.
• Activating options can increase the programme dura-
tion.
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets.
Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian-
ces in use.
• Internal electrical fault of the appliance. Contact an Au-
thorised Service Centre.
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and the basket
loading leaflet.
• Use more intensive washing programmes.
• Clean spray arm jets and the filter. Refer to "Care and
Cleaning".