Bresser National Geographic 90-81000 Guide De Démarrage Rapide page 15

Quick Start Guide
This Quick Start Guide takes you through the basic steps of the Bresser Observa-
tion Camera. A more detailed manual is available on our website.
Initial Camera Set-up:
1. Open battery cover and install 4 "C" cell batteries in correct polarity (+/-) as
indicated in battery compartment.
2. Open bottom cover.
3. Insert SD card into the camera.
4. Turn switch to "CAM" to adjust the Time and Date.
5. Press the [M] button once within 30 seconds to enter the programming
mode.
6. The word PIR will be blinking, press [OK] to confi rm the camera's operation
is PIR detection.
7. Press [UP] or [DOWN] button until the letter "T" is blinking.
8. Press the [OK] button to start the Time settings.
9. Press the [UP] or [DOWN] button to adjust the Minute setting and press
[OK] to confi rm and move to the Hour setting.
10. Repeat to set the hour and then press [OK] to confi rm and move to date.
11. Adjust the Month, Day, and Year by using [UP] or [DOWN] button. Each time
you fi nish an adjustment you MUST press the [OK] button to confi rm and
move to the next fi eld for adjustment.
12. Once done, the word - dEL - will be blinking. This stands for "Delete" and will
allow you to format your SD Card. (This will delete ALL images).
13. Press the [UP] or [DOWN] button until the word CAM or VIDEO is blinking.
14. Press the [OK] button ONCE to confi rm the camera into CAM mode or into
Video mode. The stars will be blinking.
15. Press [OK] to enter the image resolution setting.
16. Press the [UP] or [DOWN] button to select the desired resolution and press
[OK] to confi rm.
17. Then the current number of burst shoot is blinking (CAM mode) or the current
video length is blinking (Video mode).
18. Press the [OK] button to start settings.
19. Press the [UP] or [DOWN] button to adjust the setting and press [OK] to
confi rm.
20. Press the [M] button to exit.
EN
15