LG ESS Home 8 Manuel D'installation page 4

Masquer les pouces Voir aussi pour ESS Home 8:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4
Getting Started
y A battery can present a risk of electrical shock and high short-circuit current. The following
precautions should be observed when working on batteries.
a) Remove watches, ring, or other metal objects.
b) Use tools with insulated handles.
1
c) Wear rubber gloves, boots and glasses
d) Do not lay tools or metal parts on top of battery.
y Do not leave the ESS in the Fault standby state for a long time because of the battery discharge
may occur during the long standby state.
y If the battery fault occurs immediately after starting PCS it means Battery failure. Check the
battery SOC also voltage and fault information, and turn off the power of the ESS until service
action is taken.
y If the battery SOC is low the battery may charge from the grid for self-protection. (Emergency
Charging) This function is to prevent shutdown of the ESS, deep discharge and failure of the
Battery. An Emergency Charge is not an ESS fault.
NOTE
y Before making connections, please make sure the PV array open circuit voltage is within 1000 V.
Otherwise the product could be damaged.
y Never use any solvents, abrasives or corrosive materials to clean this product.
y Do not store on or place against any objects to the product. It may cause serious defects or
malfunction.
y Before making a connection, make sure the PV switch on this product is switched off.
y This unit is designed to feed power to the public grid only. Do not connect this unit to an AC
source or generator. Connecting the product to external devices could result in serious damage to
your equipment.
y Serving of batteries should be performed or supervised by LG service person or trained installer.
y The battery does not discharged when the load is under the certain level.
y This product can cause current with a DC component. Where a Residual Current-operated
protective (RCD) or monitoring (RCM) device is used for protection in case of direct or indirect
contact, only an RCD or RCM of Type A (or type B) is allowed on the supply side of this product.
y This product is designed to be installed indoor use only. Do not install this product outdoor.
y This document is for your reference only. Read the installation manual on the website below.
https://www.lg.com/global/business/ess/business-resources/download
y Please check the following website for warranty policy.
https://www.lg.com/global/business/ess/business-resources/download
Indicates a risk of possible damage to the product.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ess home 10D010ke1n211D008ke1n211

Table des Matières