Pioneer VSX-534 Mode D'emploi page 109

1. INPUT SELECTOR dial: Switch the input to be played.
2. 4K indicator: Lights up when doing 4K upscaling or 4K pass through.
3. FL OFF indicator: Lights up when the display is turned off by repeatedly
pressing the DIMMER button on the remote controller.
4. ZONE A/B button: Selects an audio output destination from among "ZONE A",
"ZONE B" and "ZONE A+B". (
5. PRESET +/- button: Selects preset radio stations registered when using
TUNER. ( p39)
p10)
6. Display (
7. STATUS button: Switches the information on the display and is used to
operate RDS ( p41).
8. Listening mode button: Press "AUTO/DIRECT", "SURROUND" or "STEREO"
to switch the listening mode. (
9. Remote control sensor: Receives signals from the remote controller.
• The signal range of the remote controller is within about 16´/5 m, at an
angle of 20° on the perpendicular axis and 30° to either side.
10. SOUND RETRIEVER button: Turns on/off the Sound Retriever function that
provides better sound quality for compressed audio.
11. MASTER VOLUME
12. STANDBY/ON button
13. PHONES jack: Headphones with a standard plug (ø1/4"/6.3 mm) are
connected.
14. TUNER button: Switches the input to be played to "TUNER". Also, pressing
this button repeatedly switches the input between "AM" and "FM".
15. PERSONAL PRESET 1/2/3 buttons: Registers the current setting conditions
such as input selector, listening mode, etc. or call the registered settings.
( p44)
16. BLUETOOTH button: Switches the input to be played to "BLUETOOTH".
17. SETUP MIC jack: The supplied speaker setup microphone is connected.
( p73, 84)
p42)
p49)
Contents Connections
≫
9
Front
Playback
≫
Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫