Bosch SHX36L Guide D'entretien Et D'utilisation page 14

Care and Maintenance
Check/Clean the Stainless Steel
Inner Door and Tub
Clean the outer edges of the inside door panel
regularly to remove debris that might collect there
from normal loading.
If spots begin to appear on the stainless steel tub
or inner door, make sure the rinse agent reservoir
is full.
Check/Clean the Spray Arm
Nozzles
Occasionally check the spray arms to ensure that
the spray arm nozzles (holes) are unobstructed.
You must remove the spray arms to check them
for obstruction.
To remove the top spray arm:
1. Remove the empty top rack from the
dishwasher.
2. Turn the
rack upside-
down. The
top spray
arm is held
in position
by a locking
nut as
shown in
Figure 19A.
Turn the
locking nut
counter-
clockwise
1/8 turn and
remove it,
as shown in Figure 19B to release the spray
arm.
3. Remove the spray arm as shown in Figure
20.
4. Look for
obstruction
in the spray
nozzles.
5. If the spray
nozzles
need
cleaning,
flush them
under running water.
12
Figure 19
A
B
Figure 20
To reinstall the top spray arm:
1. Return the top spray arm to its installed
position.
2. Return the locking nut to its installed
position and turn it 1/8 turn clockwise.
3. Return the top rack to the top rack roller
guides.
To remove the bottom spray arm:
1. Remove the empty bottom rack from the
dishwasher tub.
2. Grasp and lift the bottom spray arm as
shown in
Figure 21.
3. Look for
obstruction
in the
spray
nozzles.
4. If the spray
nozzles
need
cleaning, flush them under running water.
To reinstall the bottom spray arm:
1. Return the bottom spray arm to its installed
position and press it so that it snaps into
place.
2. Return the bottom rack to its installed
position.
Check/Clean the Filter System
This dishwasher has a filter system that consists
of a Large Object Trap/Cylinder Filter assembly
and a Fine Filter. The filter system is located on
the inside of your dishwasher under the lower
rack and is easily accessible.
During normal use, the filter system is
self-cleaning. You should occasionally inspect it
for foreign objects and clean it when necessary.
To Remove the Large Object Trap/Cylinder
Filter Assembly:
1. Remove the bottom rack.
2. Grasp the
assembly as
shown in
Figure 22 and
turn it
counter-
clockwise
1/4 turn.
Figure 21
Figure 22