Rowenta INTENS Ultra Compact Série Mode D'emploi page 20

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT
HEPA filter to make the dust fall out.
IMPORTANT
between the folds of the HEPA filter to avoid
damaging it.
IMPORTANT
damaged, change it. The HEPA filter ref.
ZR 0008 is available from your dealer or
Approved Service Centres.
4 • Cleaning the foam motor-
protection Filter
IMPORTANT
Every six months, wash the
foam filter protecting the motor.
Remove the cover from the separator
(fig.19)
and remove the Air Force System
(fig.20)
separator
Remove the foam filter protecting the motor
(fig.30)
. Wash and squeeze out the foam
filter protecting the motor
Leave this foam filter protecting the motor to
dry for at least 12 hours before fitting it again
(fig.24)
.
Fit the foam filter protecting the motor
(fig.31)
and the Air Force System separator
(fig.32)
. Fit the separator cover
TROUBLESHOOTING
IMPORTANT
As soon as your vacuum
cleaner starts to malfunction, and before
performing any checks stop the appliance by
pressing the Start/Stop switch.
If your vacuum cleaner does not start
• The appliance is not plugged-in. Check that
the appliance is correctly plugged in.
Shake the folds of the
Do not insert the tool
If the HEPA filter is
.
(fig.24)
.
(fig.33)
IMPORTANT
protecting the motor to dry completely
before fitting it into the appliance again.
Ensure that this foam filter protecting the
motor is completely dry before fitting it to the
appliance.
5 • Cleaning the seal of the
dust compartment
Remove the dust compartment as follows:
Lower the handle to release the dust
compartment and remove it
Clean the edges of the seal of the dust
compartment using a cloth
Fit the dust compartment
the handle to lock the dust compartment
(fig.18)
.
6 • Cleaning your vacuum
cleaner
Clean the housing of the vacuum cleaner
with a soft and humid rag and let dry with a
(fig.35)
dry rag
Wash the dust compartment in clear water,
then dry it with a dry cloth.
IMPORTANT
aggressive or abrasive products. The
transparency of the dust compartment
and/or the separator cover may change in
.
time
but
performances of the appliance.
If there is no suction
• An accessory, the tube, the flexible tube or the
pipe between the suction inlet (11) and the
separator are blocked: unblock them.
• The separator is blocked. Remove the cover
(fig.19)
and clean the separator filter grill.
• The black foam filter is saturated: clean the
black foam filter (see page 16 paragraph 2).
17
Allow this foam filter
(fig.13)
(fig.34)
(fig.17)
.
Do not use detergents, or
this
does
not
affect
GB
.
.
and raise
the

Publicité

Table des Matières
loading

Table des Matières