Manufacturer's Warranty Coverage; Owner's Warranty Responsibilities; Warranted Parts - Homelite HGCA1400 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The EPA and SUMEC MACHINERY & ELECTRIC CO. LTD. are pleased
to explain the emission (where "emissions" is understood to mean both
exhaust and evaporative emissions) control system warranty on your
2010 model year small off-road engine (SORE). In USA, new SORE must
be designed, built, and equipped to meet the State's stringent anti-smog
standards. SUMEC MACHINERY & ELECTRIC CO. LTD. must warrant the
ECS on your SORE for the period of time listed below provided there has
been no abuse, neglect or improper maintenance of your SORE.
Your ECS may include parts such as the carburetor, fuel-injection system,
the ignition system, catalytic converter, fuel tanks, fuel lines, fuel caps,
valves, canisters, filters, vapor hoses, clamps, connectors, and other
associated emission-related components.
Where a warrantable condition exists, SUMEC MACHINERY & ELECTRIC
CO. LTD. will repair your SORE at no cost to you including diagnosis,
parts and labor.

MANUFACTURER'S WARRANTy COVERAGE:

This emission (or emissions) control system is warranted for two years. If
any emission-related part on your equipment is defective, the part will be
repaired or replaced by SUMEC MACHINERY & ELECTRIC CO. LTD.

OWNER'S WARRANTy RESPONSIBILITIES:

As the SORE owner, you are responsible for performance of the required
maintenance listed in your operator's manual. SUMEC MACHINERY &
ELECTRIC CO. LTD. recommends that you retain all receipts covering
maintenance on your SORE, but SUMEC MACHINERY & ELECTRIC CO.
LTD. cannot deny warranty solely for the lack of receipts.
As the SORE owner, you should however be aware that SUMEC MA-
CHINERY & ELECTRIC CO. LTD. may deny you warranty coverage if your
SORE or a part has failed due to abuse, neglect, or improper maintenance
or unapproved modifications.
You are responsible for presenting your SORE to SUMEC MACHIN-
ERY & ELECTRIC CO. LTD.'s distribution center or service center as
soon as the problem exists. The warranty repairs should be com-
pleted in a reasonable amount of time, not to exceed 30 days. If
you have a question regarding your warranty coverage, you should
contact Sunright International of America at 770-729-9065, or write
to the following address: Sunright International of America, Inc.,
5965 Peachtree Corners E. Ste C-3, Norcross, GA 30071. ATTENTION
WARRANTY DEPARTMENT.
GENERAL EMISSIONS WARRANTy COVERAGE:
SUMEC MACHINERY & ELECTRIC CO. LTD. warrants to the ultimate
purchaser and each subsequent purchaser that the SORE is:
 Designed, built and equipped so as to conform with all applicable
regulations; and
 Free from defects in materials and workmanship that cause the fail-
ure of a warranted part to be identical in all material respects to that
part as described in SUMEC MACHINERY & ELECTRIC CO. LTD.'s
application for certification.
The warranty period begins on the date the SORE is delivered to an
ultimate purchaser or first placed into service. The warranty period is
two years.
Subject to certain conditions and exclusions as stated below, the war-
ranty on emission-related parts is as follows:
(1) Any warranted part that is not scheduled for replacement as re-
quired maintenance in the written instructions supplied, is warranted
for the warranty period stated above. If the part fails during the period
of warranty coverage, the part will be repaired or replaced by SUMEC
MACHINERY & ELECTRIC CO. LTD. According to subsection (4) below.
Any such part repaired or replaced under warranty will be warranted for
the remainder of the period.
(2) Any warranted part that is scheduled only for regular inspection in
the written instructions supplied is warranted for the warranty period
stated above. Any such part repaired or replaced under warranty will
be warranted for the remaining warranty period.
WARRANTy
EPA EMISSION CONTROL WARRANTy STATEMENT
yOUR WARRANTy RIGHTS AND OBLIGATIONS
Page 19 — English
(3) Any warranted part that is scheduled for replacement as required
maintenance in the written instructions supplied is warranted for the
period of time before the first scheduled replacement date for that part.
If the part fails before the first scheduled replacement, the part will be
repaired or replaced by SUMEC MACHINERY & ELECTRIC CO. LTD.
according to subsection (4) below. Any such part repaired or replaced
under warranty will be warranted for the remainder of the period prior to
the first scheduled replacement point for the part.
(4) Repair or replacement of any warranted part under the warranty
provisions herein must be performed at a warranty station at no charge
to the owner.
(5) Notwithstanding the provisions herein, warranty services or repairs
will be provided at all of our distribution centers that are franchised to
service the subject engines or equipment.
(6) The SORE owner will not be charged for diagnostic labor that is directly
associated with diagnosis of a defective, emission-related warranted part,
provided that such diagnostic work is performed at a warranty station.
(7) SUMEC MACHINERY & ELECTRIC CO. LTD. is liable for damages to
other engine or equipment components proximately caused by a failure
under warranty of any warranted part.
(8) Throughout the SORE warranty period stated above, SUMEC MA-
CHINERY & ELECTRIC CO. LTD. will maintain a supply of warranted parts
sufficient to meet the expected demand for such parts.
(9) Any replacement part may be used in the performance of any war-
ranty maintenance or repairs and must be provided without charge to
the owner. Such use will not reduce the warranty obligations of SUMEC
MACHINERY & ELECTRIC CO. LTD.
(10) Add-on or modified parts that are not exempted by the Air Resources
Board may not be used. The use of any non-exempted add-on or modified
parts by the ultimate purchaser will be grounds for disallowing warranty
claims. SUMEC MACHINERY & ELECTRIC CO. LTD. will not be liable to
warrant failures of warranted parts caused by the use of a non-exempted
add-on or modified part.

WARRANTED PARTS:

The repair or replacement of any warranted part otherwise eligible for
warranty coverage may be excluded from such warranty coverage if
SUMEC MACHINERY & ELECTRIC CO. LTD. demonstrates that the
SORE has been abused, neglected, or improperly maintained, and that
such abuse, neglect, or improper maintenance was the direct cause of
the need for repair or replacement of the part. That notwithstanding, any
adjustment of a component that has a factory installed, and properly op-
erating, adjustment-limiting device is still eligible for warranty coverage.
The following emission warranty parts list are covered (use portions of
this list applicable to your SORE:
1) Fuel Metering System:
a) Gasoline carburetor assembly and its internal components
b) Fuel filter (if so equipped)
c) Carburetor gaskets
d) Fuel pump (if so equipped)
2) Air Induction System including:
a) Intake pipe/manifold
b) Air cleaner
3) Ignition System including:
a) Spark plug
b) Ignition module/coil
4) Miscellaneous Items Used in Above Systems:
a) Vacuum, temperature, and time sensitive valves and switches
b) Hoses, belts, connectors, and assemblies
5) Evaporate Control:
a) Fuel Line
b) Fuel Line Fittings
c) Clamps

Publicité

Table des Matières
loading

Table des Matières