Daitsu ADP 9AM Mode D'emploi page 37

07ManPORTATILDaitsuEng 7/2/07
OPERATING INSTRUCTING FOR THE AIR CONDITIONER
(2) Cooling operation
- Press the "MODE" button several times until the "COOL" indicator light comes on.
- Press the "TEMP SETTING" buttons " " or " " to select your desired room temperature. (17ºC-30ºC/63ºF-86ºF)
- Press the "FAN SPEED" button to choose the fan speed.
(3) Dehumidifying operation
- Press the "MODE" button several times until the "DRY" indicator light comes on.
- Press the "TEMP SETTING" buttons " " or " " to select your desired room temperature. (10ºC-30ºC/50ºF-86ºF)
- The fan will run at a fixed speed at this setting.
- Keep windows and doors closed for the best dehumidifying effect.
- Do not put the duct to window.
(4) Heating operation
- Press the "MODE" button several times until the "HEAT" indicator light comes on.
- Press the "TEMP SETTING" buttons " " or " " to select your desired room temperature. (17ºC-30ºC/63ºF-86ºF)
- Press the "FAN SPEED" button to choose the fan speed.
- Do not put the duct to window.
(5) Fan operation
- Press the "MODE" button several times until the "FAN" indicator light comes on.
- Press the "FAN SPEED" button to choose the fan speed.
- Do not put the duct to window.
(6) Timer operation
Setting the on timer:
- Press the "TIMER ON" button when the air conditioner is off. Select the time you need the unit start to operate.
- The Operation Paned Window will display "ON"
- The starting time is adjustable from 0.00 to 24.
Setting the off timer:
- Press the "TIMER OFF" button when the air conditioner is on. Select the time you need the unit turn off. The Operation Panel
Window will display "OFF".
- The turning off time is adjustable from 0.00 to 24.
(7) Water pump drainage
- Connect the water pump drain hose to the unit before operate. When the water level of the internal water tank reaches a pre-
determined level, the water pump will be activated and drain the condensed water outside through the connected drain hose.
The maximum delivery lift is 3.5m. (Under this condition, attach the rubber blockage to the back hole to prevent continuous drai-
nage.)
(8) Continuous drainage
- When you plan to leave this unit unused for a long time, remove the rubber blockage form the back hole and attach a section
of the continuous drain hose to drain hose connector. All the water in the water tank would drain outside through the drain hose.
(Under this condition, the water pump is not activated.)
36
10:13 Página 36
(Cooling only type without heat feature)