Erreka VIVO-D102 Manuel De L'installateur page 51

Connection of safety transmitter-receiver photocells in closing (SG.C)

We recommend installing
photocells.
1 Complete the connections as shown in the figure.

If neither photocells nor a mechanical strip are used,
place an electrical bridge between cable connectors
3 and 4 of the control board (COM - SG.C).
2 Duly programme the operator:

Closing photocells with pre-testing: C511

Closing photocells without pre-testing: C510

Without closing photocells: C500

For further details on programming, see "Starting
up and programming" on page 48.
INSTALLATION
closing safety
47
VIVO-D102 Control board