Erreka VIVO-D102 Manuel De L'installateur page 50

INSTALLATION
Peripheral connections
O
When installing batteries, ensure they are connected through an external
charger (CHG). Do not connect them directly to the control board.
The ADO01 kit is recommended, consisting of a charger and two 12V/1.2Ah
batteries, as it has been designed for use in this control board.
A.T. Total opening key device
SG.C Closing safety device (mechanical strip or
photocell)
SG.A Pedestrian access safety device (circuit
breaker, magnetic contact, etc)
FT Output 24Vdc for photocells (cable
connectors 6 and 7)
AUX Output 24Vdc (cable connectors 7 and 8)
DEST Flashing light (230Vac, 60W max)
LG Garage light (max 2300W resistive)
ANT Antenna connection

We recommend
instructions to carry out the connections with
the control board.
46
Installation Manual
ST1
FT1
checking the accessory
R.E. Plug-in receiver
SCA SCA light (24Vdc)
STOP Release switch (normally closed), installed
only in IZAR operators with encoder and
release
SMF Traffic light card AEPS1-001
BAT Rechargeable batteries (24 Vdc)
ADO01 Charger kit (CHG) + batteries (2x 12V/
1.2Ah)
ADO01
BAT: (2x12V/1,2 Ah)
BATTERY
IN/OUT
CHG