Assembly Of The Filter - Procopi RTM SIDE classique Série Notice D'installation

1
Remove the diffuser and cover the
opening of the tube with adhesive
tape.
3
Pour the sand (granulometry
0.6/1.25) in carefully to avoid
damaging the laterals.
Remove the tape and put the
diffuser back in position.
5
Wind Teflon tape 4 times around the
threading on the pressure gauge,
remove the plug on the multiport
valve and screw the pressure gauge
into this position.
7
Assemble the air bleed valve on
the lid.
*
Valve available as an option

ASSEMBLY OF ThE FILTER

2
Check that the drain valve is
closed.
Fill the pump with water until the
water level is 5 cm above the
laterals.
4
Fit the o-rings into the grooves on
the bulkhead fittings.
6
Fit the multiport valve: position the
*
lower fitting first, then the upper
fitting. Tighten the nuts moderately.
8
Install the lid and lid o-ring.
To facilitate assembly, wet the seal
or use the lubricant, Magic Lube
(code 1397200).
Caution: the use of any other type
of lubricant is prohibited.
14/40 2010/03 - Indice de révision : D - Code : 0026690
*
*