Soundcast VG tx Mode D'emploi page 5

Optical out
from TV
To Optical in
Power button, LED indicators
Adjustable
Mounting Tabs
Audio inputs/outputs, Power Connector
Pairing
Note: The VGtx and your Bluetooth® device should be no more than one
meter apart when pairing (the closer the better until paired).
1. Power on your headphones, speaker or other compatible A2DP Blue-
tooth® profile device and engage pairing mode.
2. Confirm VGtx is powered-up by connecting USB power cable to power
supply or by turning on with (1 second) mutl- function/power button press
if unit had been previously turned off.
Image A
Optical out to
Soundbar/Amplifier
Image B
facing up
Adjustable
Mounting Tabs
Facing Down
3. Place the VGtx into pairing mode: press and hold the power button
(6) seconds until the VGtx LED indicators go from slow flashing blue to
alternating red and blue.
4. When pairing is complete the VGtx Bluetooth indicator will light a solid
blue; pairing has been established.
Note: Leave the VGtx continuously connected to USB power, and powered
on to automatically reconnect when the last paired device is within range.
If powered off or disconnected from USB power, the VGtx should automat-
ically reconnect with the last paired receiving device when both devices
are powered on and within range.
*VGtx with TV Audio
The VGtx paired with any VG series speaker will utilize AptX Low Latency
ensuring no delays or lip syncing issues. Other manufacturers speakers
which have AptX Low Latency will also benefit from the AptX Low Latency.
*TWS mode is not recommended for TV audio as the VGtx must default
back to standard aptX when TWS is in use.
Clearing Memory / Factory Reset
The VGtx only has pairing memory for a single device. In order to pair the
VGtx to a new device, you must re-enter pairing mode by pressing the
multi-function/power button for (6) seconds, this will both CLEAR the
previously paired device and put the VGtx into pairing mode where a new
device can be paired following the "Pairing" instructions discussed above.
To factory reset the VGtx and clear pairing memory, press and hold the
multi-function/power button for (10) seconds
until the both the blue and red LED indictors blink rapidly, then release
the multi-function/power button. This indicates that the VGtx has been
successfully reset and pairing memory cleared.
Note: After a factory reset, the internal Bluetooth® pairing memory will
be deleted. You will need to re-pair any previously paired device in order
for the VGtx to properly connect to it again.