Hobot 188 Mode D'emploi page 48


A power cord must be used for the HOBOT-188 to function properly.

How to put the device onto glass:
(1) Turn power switch on. Make sure fan is running.
(2) Put device onto glass and keep 10cm away from the window frame.
(3) Check if device is sticking to the glass before releasing it.

How to remove the device from glass:
(1) While device is running, hold the safety rope with one hand and take device down from glass
with the other hand.
(2) Remove the device to a safe area, then turn it off.

Safety rope and buckle:
(1) Before using, check to see if the safety rope is broken or if the knot is loose.
(2) Fasten the safety rope and tie to an indoor fixture before operating.

UPS (Uninterrupted Power System) function:
(1) The UPS function will be enabled automatically when no electric power is supplied. The
backup time of this UPS is 20 minutes.
(2) If no electric power is supplied, the device will stop automatically, sound an alert, and flash a
red light. The user should take the device down from the glass as soon as possible.
(3) The safety rope can be used to pull the device back. Gently pull the safety rope at an angle
close to the glass to prevent it from falling off.

Make sure the battery is fully charged (green light ON) before use:
(1) First, turn off the power switch on the device. Plug it into a power source. Orange light ON
means charging.
(2) Green light ON means the battery is fully charged.

Other things to pay attention to:
(1) Do not use on frameless glass.
(2) Make sure to put the cleaning ring onto the cleaning wheel correctly to avoid leakage.
(3) Do not use it on rainy or humid days.
(4) For windows with no balcony, a warning area must be established on the ground below to
prevent people from coming near it.
Mobex Handels AG  Grenzweg 1  5610 Wohlen  Switzerland