Honeywell MN10CCD Série Mode D'emploi page 7

INSTALLATION (CONTINUED)
2. The Window Brackets allow you to install to windows and balcony doors of different heights or
width.
Adjustable Knobs
To install the window bracket to the window frame, you need to adjust the height or width of the
window bracket by extending the length according to the height or width of the window. When the
length is set, tighten the Adjustable Knobs (preinstalled on the window bracket) to ensure the window
bracket is secured in the desired position. Use one or all three pieces of window bracket as needed.
Note: After setting the window bracket to the size of your window, please remove it from the window
and follow the instructions below.
3. Connect one hose to the rear air exhaust outlet on the back of the unit. Slide-in the hose
connector from left to right. Rotate clockwise to ensure the knob mechanism is locked in place.
Rotate anticlockwise to unlock the knob mechanism.
Air Exhaust
Outlet
Connect the second hose to the rear air intake outlet on the back of the unit. Slide-in the hose
connector downwards. Rotate anticlockwise to ensure the knob mechanism is locked in place. Rotate
clockwise to unlock the knob mechanism.
19.7" (50 cm)
1 part
EN 4
19.7" (50 cm) to
38.2" (97 cm)
2 parts
47.2" (1.2 m)
3 parts
Air Intake
Outlet