AEG X78263BV10 Manuel D'utilisation page 4

4 www.aeg.com
The hood is provided with a special power
cable ; if the cable is damaged, request a
new one from Technical Service.
In the case of the presence of panels and/
or walls and/or lateral wall units check that
there is suffi cient space to install the hood
and that access to the command panel is
easy.
The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
40cm from electric cookers and 65cm from
gas or mixed cookers. If the instructions for
installation for the gas hob specify a greater
distance, this must be adhered to.
4. MAINTENANCE
ATTENTION! Before performing any
maintenance operation, isolate the
hood from the electrical supply by
switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
The cooker hood should be cleaned
regularly (at least with the same frequency
with which you carry out maintenance of the
fat fi lters) internally and externally. Clean
using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
Warning! Failure to carry out the basic
cleaning recommendations of the
cooker hood and replacement of the
fi lters may cause fi re risks. Therefore,
we recommend observing these
instructions.
The manufacturer declines all responsibility
for any damage to the motor or any
fi re damage linked to inappropriate
maintenance or failure to observe the above
safety recommendations.
4.1 Grease fi lter - The grease fi lter must
be cleaned once a month using non
aggressive detergents, either by hand or
in the dishwasher, which must be set to a
low temperature and a short cycle. When
washed in a dishwasher, the grease fi lter
may discolour slightly, but this does not
affect its fi ltering capacity.
4.2 Charcoal fi lter - Washable activated
charcoal fi lter
The charcoal fi lter can be washed once
every two months using hot water and a
suitable detergent, or in a dishwasher at
65°C (if the dishwasher is used, select the
full cycle function and leave dishes out).
Eliminate excess water without damaging
the fi lter, then remove the mattress located
inside the plastic frame and put it in the
oven for 10 minutes at 100° C to dry com-
pletely. Replace the mattress every 3 years
and when the cloth is damaged.