Partition For Paper Roll - Citizen CT-S801 Mode D'emploi

3.6 Partition for Paper Roll

Set the partition to the width of the paper roll you are loading.
The partition is set at the factory to the position shown below.
For 3-inch type: 80-mm wide paper roll
For 2-inch type: 58-mm wide paper roll, 60-mm wide paper roll
1. Turn off the power.
2. Pull the cover open lever forward and open the paper cover.
3. Set the partition in a slot that matches the size of the paper roll you are using.
However, to use an 83-mm wide paper roll, remove the partition.
Or, when you are using a 60-mm wide paper roll with the 2-inch type, remove the
partition installed for 58-mm.
4. Refer to "5.3 Manual Setting of Memory Switches" to change the paper width
settings.
CAUTION
Make sure the partition is not slanted when setting it for 58-mm or 60-mm paper rolls.
(2-sheet partition installed.)
Partition
*1
*2
*1
Notes:
*1: 2-inch type (58/60 mm)
*2: 3-inch type (80/83 mm)
— 26 —