Rear Panel Features - Numark CDN77USB Guide D'utilisation Rapide

REAR PANEL FEATURES

1. VOLTAGE SELECTOR -- - Set this switch to the voltage for your location.
2. POWER PLUG CONNECTOR – Plug your supplied power cord in here.
3. CONTOLLER CABLE CONNECTOR – Use the included controller cables to connect the CD player (bottom) to the
controller unit (top).
4. RCA AUDIO CONNECTORS – Connect your CD player to your mixer from these line level outputs.
5. REMOTE START CONNECTOR – To use CDN77USB's fader start features, connect these jacks to a fader start-
compatible mixer using a standard fader start cable (not included). Every time you move the crossfader on the mixer
towards one deck, that deck will automatically start playing. When you move the fader away from that deck, the deck
will stop playing.
LCD FEATURES
1. PLAY – This shows when the unit is playing.
2. CUE – Lit continuously when the unit is paused at a
cue point.
3. CD / USB – Indicates whether you are playing tracks
from a loaded CD or a connected USB device.
4. TRACK / FOLDER NUMBER – Shows the current
track or folder number. When viewing or playing a
program, the number will have a "P" in front of it
("P01," "P02," etc.), indicating the number of that
track in the program.
5. TOTAL TRACK – Displays the total number of tracks available on the CD or USB device. (When in Folder View, it will
display the total number of folders available on the USB device.)
6. MINUTES – Shows the minutes elapsed or remaining depending on mode setting.
7. SECONDS – Shows the seconds elapsed or remaining depending on mode setting.
8. FRAMES – The CD player breaks down a second into 75 frames for accurate cueing. This shows the frames elapsed or
remaining depending on mode setting.
9. TIME MODE – Indicates whether the time shown on the LCD is the elapsed time for the track, remaining time for the
track, or total remaining time for the entire CD.
10. TIME BAR – Shows either time remaining or elapsed depending on the setting of the TIME button.
11. PLAY MODE – Shows when the unit is set to Single Mode (the deck will stop at the end of each track) or Continuous
Play Mode (the entire disc will be played without interruption). This function is controlled by the SINGLE button.
12. RELOOP – Indicates when a loop is programmed.
13. BPM – Displays the tempo in BPM (beats per minute) of the current track. When "AUTO BPM" is displayed, it is a
tempo that has been automatically detected.
14. PITCH – Shows the percentage change in pitch.
15. MT (MASTER TEMPO) – Indicates that the MASTER TEMPO button is engaged.
16. PG (PROGRAM) – Indicates that a program is playing.
17. TEXT DISPLAY – Displays the folder name or file name when navigating MP3s.
18. iD3 TAG – Displays what kind of iD3 tag is shown in the TEXT DISPLAY.
3
4
4
5
3
1
2
3 3
5
1 11
Single Cont. Elapsed Total Remain
TRACK
4
FOLDER
2
Total
3
TITLE
ALBUM
ARTIST
5
18 17
6
4
4
9 14
10
RELOOP
8 13
6 7
12
15
MT
16
PG