Trigano Jardin OSMOSE Ovale Notice De Montage Et Guide D'utilisation page 102

Position the connecting plates (round part).
2176
0341
2276
0341
INSTALL THE GROUND SHEET OR GEOTEXTILE FILM (note: the ground sheet is not included in all kits)
10 cm
It is important to backfill 8 to 10 cm (mound of fine sand) all around the base of the inside
Sides
of the pool and, particularly, along the sides of the pool, and to cover the entire surface of
the pool with a 5 cm layer of sand. The sand prevents the liner from sliding under the
Sand
5 cm
metal sheet and protects it from the protruding parts of the pool structure that could
perforate it (the pressure plates and strap bolts must be totally covered).
Cover the prepared ground with a geotextile film that goes 10 to 12 cm up the wall. Stick
the film to the wall in various places using double-sided adhesive tape. The geotextile film prevents algae from spreading under
the liner
POOL WALL CUT OUTS
After assembling the pool wall, make the skimmer and discharge nozzle cut outs using metal cutters or sharp pliers. File the edges
of the cut outs and apply rustproofing agent. We advise wearing gloves during this process.
NOTE: For kits containing two half-walls, perform the cut outs on just one of the half-walls and stick a protective strip
(duct tape) on the unused cut outs on the inside of the pool in order to protect the liner.
OSMOSE Oval 102 Assembly Guide 880115-rev A