Wire Feeder; Warranty - CEVIK PRO CE-PROMIG 200 Manuel D'instructions

EN

11.3 Wire feeder:

Part
Pressure
Check if the pressure-adjusting handle is
adjusting
fixed and adjusted to the desired position.
handle
Check if there is dust or spatter inside the
hose or beside wire-feeding wheel.
Wire-
Check if there is a diameter agreement of
feeding
wire and wire-feeding hose.
hose
Check if rod and wire feeding groove are
concentric.
Check if there is an agreement of wire
Wire-
diameter and wire-feeding wheel.
feeding
wheel
Check if the wire groove is blocked.
Pressure Check if the pressure adjusting wheel can
adjusting rotate smoothly, and it's physically
wheel complete.
11.4 Cables:
Part
Check if the cable of torch is twisted.
Torch
cable
Check if the coupling plug is in loose connection.
Check if the cable is physically complete.
Output
cable
Check if insulation damage or loose connection exists.
Check if the cable is physically complete.
Input
cable
Check if insulation damage or loose connection exists.
Check if the earth cables are well fixed and not short-
Earth
circuited.
cable
Check if this welding equipment is well grounded.

12. WARRANTY.

Duration: The guarantee period is 24 months for users who do not carry out a professional activity with the
equipment. The warranty period is 12 months in all other cases.
Coverage: The guarantee requires the manufacturer CEVIK S.A. to repair or replace for free all components
subject to verified manufacturing flaws. The CEVIK Assistance Service will be responsible for the repair or
replacement in the shortest possible time, compatibly with the internal commitments of the service, without
any obligation of compensation or reparation for direct or indirect damages.
Check
Check
77
Remarks
The unfixed pressure-adjusting handle
leads to the unstable welding output.
Remove the dust.
Non-agreement of the diameter of wire
and wire-feeding hose possibly leads to
the excessive spatter and unstable arc.
Unstable arc possibly occurs.
Non-agreement of wire diameter and
wire-feeding wheel possibly leads to the
excessive spatter and unstable arc.
Replace it if necessary.
Unstable rotation
incompleteness of the wheel possibly
leads to unstable wire feeding and arc.
Remarks
The twisted torch cable leads to
unstable wire feeding and arc.
Relevant measures should be
taken to obtain stable weld and
prevent the possible electric
shock.
Relevant measures should be
taken to prevent the possible
electric shock.
or physically