Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
7. TECHNICAL SPECIFICATIONS.
DATOS TÉCNICOS.
VOLTAGE / FRECUENCY.
POWER SUPPLY CAPACITY.
EFFECTIVE POWER.
OUTPUT VOLTAGE.
VACUUM VOLTAGE. (U₀)
CURRENT ADJUSTMENT RANGE.
FUNCTION.
DUTY CYCLE. (*)
POWER FACTOR.
EFFICIENCY.
TYPE OF WIRE FEED.
POST-FLUJO SOLDADURA TIG
Ø WELDING WIRE.
Ø MAX ELECTRODE.
INSULATION CLASS.
PROTECTION CLASS.
MACHINE SIZE.
MACHINE WEIGHT.
(*) Note: The welding duty cycle is the percentage of actual continuous welding time that can occur in a ten
minutes cycle. For example: 20% at 200amps- this means the welder can weld continuously at 200 amps for
2 minutes and then the unit will need to be rested for 8 minutes.
The duty cycle can be affected by the environment in which the welder is used. In areas with temperatures
exceeding 40℃, the duty cycle will be less than stated. In areas less than 40 ℃, higher duty cycles have been
obtained
All tests on duty cycles have been carried out at 40℃ with a 50%. So in practical working conditions the duty
cycles will be much greater than those stated above.
8. INSTALLATION AND START UP.
8.1. MIG/MAG welding process.
8.1.1 Fitting the spool
8.1.1.1 open the cover door for the wire feed compartment. Remove the wire spool retainer (18) by threading
off anti clockwise.
8.1.1.2 fit the 200mm diameter wire spool to the spool holder, ensuring the end of the wires exits towards
the wire feeder from the bottom of the spool. Refit the wire spool retainer (18) and tighten finger tight.
8.1.1.3 set the spool brake tension by rotating the adjustment screw (19) using an Allen wrench. Clockwise
to increase brake tension, anti-clockwise to decrease brake tension. The spool brake tension should be set so
that the spool can rotate freely, but does not continue to rotate once the wire feed stops. This may need to
be adjusted as the wire is used up and the spool weight decreases.
8.1.2 Loading wire feeder
8.1.2.1 release the wire feeder tension arm (14) by pivoting the wire feed tension adjuster (13) as pictured
below
PROMIG200
1~ 230V. – 50/60Hz.
8,05 KVA.
3,68 Kw.
16,5-24 V.
51 V.
50-200 A.
MIG-MAG / MMA / TIG.
20%.
0,76.
85%.
Internal / External.
1 second.
0,6/0,8/1,0 mm.
4,0 mm.
H
IP21S
489x210x327 mm.
12 Kg.
67
Publicité
Table des Matières
