CEVIK PRO CE-PROMIG 200 Manuel D'instructions page 73

EN
9.1.8 Wire check function: press the Right Button (4) again to enter to the wire check mode, rotate Right knob
(2) to select ON/OFF
9.2. Feeding the wire.
9.2.1 Remove the conical nozzle (24) and the welding tip (25) from the torch. The conical nozzle is removed
by turning clockwise and pulling off simultaneously. The welding tip threads out of the tip adapter.
9.2.2 With the wire feed cover door still open pull the torch trigger (20) and check that the wire is feeding
smoothly through the feed roller and into the torch.
9.2.3 Now stretch the torch lead and handle out as straight as possible from the machine and select the wire
check function. This will start the feed motor running at full speed to feed the wire through the torch liner.
9.2.4 Once the wire comes out past the end of the torch neck, pull the torch trigger or press any button on
the display to stop the automatic wire feed.
9.2.5 Close the wire feed cover door.
9.2.6 Replace the welding tip (25) and conical nozzle (24) back onto the torch neck and trim off any excess
wire. You are now ready to weld!
9.3. MMA/STICK mode operation.
Note - MMA/Stick Welding requires an MMA lead set .
9.3.1 Connect Earth Lead Quick Connector (23) to the positive (+) output welding terminal (6).
9.3.2 Connect Earth Clamp (22) to the work piece. Contact with workpiece must be strong contact with clean,
bare metal, with no corrosion, paint or scale at the contact point .
9.3.3 Connect the ARC/electrode holder lead (28) to the negative (-) welding output terminal (8). Note – some
welding electrode types utilize different connection polarity. If in doubt, contact the electrode manufacturer.
9.3.4 Turn the machine on at the Mains Power Switch (10).
9.3.5 Press the Left button (3) to mode selection, and select the mode by Left knob (1), and press the Left
knob (1) to confirm the MMA selection.
73