Specific Safety Rules - CEVIK PRO CE-PROMIG 200 Manuel D'instructions

EN
• Do not alter or misuse the machine. This machine was built with accuracy. Any alteration or
modification not specified is a misuse and can lead to dangerous situations.
• The use of an appropriate safety device, such as a thermal and differential switch, is recommended
when using electrical equipment.
5.5. REPAIR.
• The repair of the machine must be carried out only by qualified staff. Repair or maintenance
performed by an unqualified person can lead to risk of injury.
• Only the spare parts or accessories recommended by the manufacturer should be used for the
maintenance of the machine. Follow the instructions in the maintenance section of this manual.
The use of unauthorized parts or failure to follow maintenance instructions may result in the risk of
electric shock or injury.
6. SPECIFIC SAFETY RULES FOR WELDING MACHINES.
6.1. THERMAL PROTECTION.
The equipment is protected against thermal overloads via an automatic recharge thermostat. When the
set maximum temperature is reached, the protection will cut off the power circuit current and the
WARNING display 1 will be shown. DO NOT TURN OFF OR DISCONNECT THE EQUIPMENT WHILE THE
THERMAL PROTECTION IS ACTIVE, AS DOING SO MAY CAUSE SERIOUS DAMAGE TO THE MACHINE.
After a few minutes, the warning light will go out and the power will come back. The equipment will then
be ready to resume operation.
6.2. PROTECTION AGAINST OVERLOAD.
The equipment is protected against the voltage or current peaks caused by the power supply to which it
is connected (public network, generator, etc.), if it occurs, the welding current will be interrupted and
the WARNING! display 2 will be shown. Follow ther instructions.
CAUTION: Use the equipment only following the procedure provided in this manual. Misuse can
be dangerous for people, animals and things.
The user of the welder is responsible for his own safety and that of others: it is key to read, understand
and align with the basic rules contained in this manual. Make sure that the current absorption and the
protection of the electric line correspond to those of the machine and the outlet.
6.3. ASSESSMENT OF THE WORK AREA.
Before installing welding equipment, the user must perform an assessment of potential electromagnetic
issues in the surrounding area. The following should be considered:
64