Général Switch - DOCRILUC BMR Manuel D'utilisation Et D'entretien

HOW TO CHANGE THE
SETPOINT
COMPRESSOR THERMOSTAT
FAN
TURN ON/ OFF
Press until appear
To turn off the computer press the button for 5 sec until appear
Check set point
Press "set" 1 sec and the set point or set point will appear. Release key.
Up the set point
Press "up" .Release key.
Lower set point
"down" . Release key.
Press "a
To set the new value, press
Although it is possible to select or reprogram the temperature by manipulating the thermostat, it is not advisable, as this may cause the improper
operation of the unit, changing the purpose for which it was programmed, and for this reason such manipulation should never be done.
The user of this unit will be responsible for the damage caused to it through non-compliance with the observation described in the above point.
The units designed for the storage of frozen foods are suitable for the conservation of frozen foods and not for freezing the product.
The environmental operational limits established for the units are shown by climatic category:
Push "up" or "down" to change the value and
push 1 sec or wait for 10 sec.
GÉNÉRAL SWITCH
ON to turn on the unit.
and appears the value of the temperature of the room probe.
• One the inside of the unit is clean, connect the power supply
and place the switch in the
be lit up. The thermostat display shows the air temperature
inside the unit.
• Three minutes after turning on the switch, the LED showing the
compressor is working will light up permanently.
• The initial temperature that is shown on the thermostat display
will be the ambient temperature. As the machine works, the
temperature
temperature.
OFF and the condensing unit will stop working.
I/ON
position. The switch should
will reduce until it reaches its operating