Control Panel Functions - Lorell LLR33568 Manuel Du Propriétaire

OPERATION INSTRUCTIONS
A
Timer Display
C
Mode Display
1. Check that neither the appliance nor the power cable has been damaged in any
way during transportation when first using the heater.
2. Place the heater on a firm level surface, at least 3' ('0.9 m) away from any
wall and any other objects such as furniture, curtains, plants or combustible
material.
3. Plug into standard 120 V AC, 60Hz source.
IMPORTANT: Your heater is equipped with a polarized alternating current line
plug (a plug having one blade wider than the other). This plug will fit into the
power outlet only one way. This is a safety feature. If you are unable to insert
the plug fully into the outlet, try reversing the plug. If the plug should still fail
to fit, contact your electrician to replace your outlet. DO NOT the safety alter
features of the polarized plug.
4. Heat setting
Turn on the power switch and press the ON/OFF
Press MODE button to select the heat setting.
Press ON/OFF
working. When the heater is turned on, press MODE button to select appropriate
setting, which is shown in the LED as follows:
HI: Heater operates at a higher wattage, approximately 1500W.
LO: Heater operates at a medium wattage, approximately 900W.
ECO: The heater is automatically select the working setting (HI/LO) according to the
settled temperature.
LLR33568_Assembly_Instructions.indd 4
A
B
C
D

Control Panel Functions

button again , the LED will be turned off and the heater will stop
B
Temperature Display
D
Function Button
button to turn on the heater.
4
: Temperature decrease
: ON/OFF button
: Temperature increase
: Timer button
: Mode button
5/26/15 5:33 PM